China
HomeHome Resources Industry News

How to Use a Water Pump Correctly: Advice from the Pump Factory

Industry News 2026-09-17 pump operationwater pump maintenancemotor windinginsulation resistancepump start-up
Regular checks before start-up, such as verifying the motor winding, shaft rotation, fuse rating and impeller operation, help ensure a water pump runs safely and reliably.

Changsha Circulating Pump Factory explains how to use a water pump correctly. Each time the pump is put into service, after the power is switched on, observe its operation carefully: the discharge should be continuous and even, and the pump should run without vibration or noise before it is accepted for use. If the pump stops suddenly during operation, cut off the power immediately and investigate the cause. The interval between two starts should be long enough for all the water in the pump to drain back. Starting too early will burn out the motor because of excessive resistance and water hammer in the pipe. In addition, when the pump is installed in a well, make sure that the pump flow matches the normal yield of the well; otherwise the pump will run dry and the motor will burn out.

    To ensure normal operation of the pump, it should also be inspected before use.
    1. Use a multimeter to check whether the motor winding is open-circuited. Insulation can be measured with a 500 V megohmmeter; if the insulation resistance is below 0.5 MΩ, the pump must not be used.
    2. Remove the strainer and turn the pump shaft to check whether it rotates freely; if it does not, adjust it before use.
    3. Check whether the fuse rating of the switchgear is appropriate, and never replace a fuse with other wire.
    4. Switch on the power and check whether the impeller runs normally (the power-on time must not exceed 3 to 5 seconds, otherwise the power supply may burn out) 
 

Related ArticlesRELATED NEWS

View More
WhatsApp
Top